c) Used Marshall & Williams sheet take-off consisting of (3) 73" face chrome rolls mounted in a vertical arrangement for down stack operation at approximately an 84" centerline height. Equipment # Z4330, PO # 3249-D1-50002, model # 2891, SO# 36343. Top roll is 18" in diameter while middle and bottom rolls are 24" in diameter. Top and bottom rolls are hydraulically actuated with heavy-duty cylinders. Includes (2) spare unused 24" OD polished chrome rolls, (1) spare unused 18" polished chrome roll and (1) spare unused rubber covered pull roll. Each roll is individually driven with the top roll having a 5 hp dc drive system through a precision two stage gearbox while the middle and bottom rolls are each driven by a 7.5 hp DC motor through a precision two stage gearbox. Bottom roll can also be adjusted via gear head motor driven wedge system with LVDT on each side of the roll. Roll temperature via a Marshall & Williams (3) zone stand-alone temperature control system each with 7.5 hp pump, heat exchangers and heaters. Downstream from the cooling/polishing stand is an additional cooling stand consisting of (3) 73" face x nominal 10" diameter chrome plated rolls with rotary unions mounted in approximately a 45 degree incline. Equipped with pull roll system consisting of (1) approximately 6" diameter chrome rubber roll with rotary union and (1) rubber covered roll.

d) Used 72" wide wysong electromechanical shear rated at 14 gauge in mild steel, model 1472P.