| Reciprocating Screw Blow Molding Machine with Flash Automation |
* Innovative "Top Grip" stripper
system places bottles into transfer station, eliminates cumbersome
swing arm takeaway * Vertical Trimmer allows bottles to remain standing in upright position for easier transition to down-line processes * Custom designs available for non-traditional bottles |
| * 100% unobstructed access to clamp area for fast, easy change-overs
* Top Grip eject leaves area under molds clear for removal of purgings and non-formed bottles at start-up * Wide punch platen allows single or multiple nest/die setups * Keyed backplate allows quick nest/die changes |
| GENERAL: * 11,000 pounds net weight * 15 tons chilled water required, molds and machine * 40 CFM @ 100 PSI compressed air required |
| HYDRAULIC-MODULAR POWER UNIT: * Rexroth hydraulics with proportional control valves * 75 HP electric motor, 230/460 volt, 3 phase, 60 Hz, 1800 RPM * 60 GPM hydraulic pump * 150 gallon reservoir |
| CLAMP UNIT: * 24" or 32" wide opening * Maximum opening 30", minimum shut height 9.0" * 15" maximum daylight * Rotary toggle clamp mechanism * 50 ton clamp force * Optional side shift 6.0", for 24" wide clamp only |
| EXTRUDER: * 2.5" (63 mm) diameter, 24/1 (L/D) ratio reciprocating screw * General purpose screw with 200 lbs/hr for HDPE * High efficiency screw with 275 lbs/hr for HDPE * Adjustable extruder height for die/mold settings * 2.25 pounds (1 kg) maximum single shot * Hydraulic drive with radial piston motor, 0-150 RPM * 3 zone extruder temperature controls, fan cooling |
| ELECTRICAL: * Solid state PLC with file storage for multiple jobs * Integrated parison programmer controls available * 230/460 dual voltage heater bands * 140 full load amps @ 460 volts |
 |