| Continuous Extrusion Blow Molding Machine |
* Quick mold and tooling setup * Quick color changes * Quick height adjustments with T-square arrangement * Quick payback due to low capital cost |
| GENERAL: * 3,100 pounds net weight * 3-5 tons chilled water required, molds and machine * 3 CFM @ 100 PSI compressed air required |
| SCREW MECHANISM: * 1.500" (38 mm) diameter, 24/1 (L/D) reciprocating screw * Bi-metallic barrel * Hydraulic motor screw drive, variable 0-175 RPM * 70 pounds per hour (32 kg) HDPE output * 225 gram full shot capacity, HDPE * 75 pound (34 kg) hopper capacity * 3.25" x 8" stroke injection cylinder |
| CLAMP MECHANISM: * 2.5" Bore X 10.0" stroke hydraulic cylinder, 5 tons force * 6" minimum platen opening, 20" maximum platen opening * 10" x 10" (L x W) usable platen area * T-square arrangement for rapid mold installation |
| HYDRAULIC: * 19 GPM variable volume, pressure compensated piston pump * Manifold mounted directional valves and flow controls * 35-gallon reservoir capacity, with level/temperature safety switch * Spin-on filter element with indicator gage |
| ELECTRICAL: * 25 HP, 1800 RPM, 220/440 volt, 3 phase, 60 Hz motor * 220 volt heater bands, 9.5 kW heater load, single head * 2-zone extruder temperature controls, fan cooling * Individual die head temperature controls, variac nozzle controls * 88 full load amps @ 220 volts, approximately 60 running amps * Mitsubishi programmable controller * Mitsubishi touch-pad data access unit |
| OTHER STANDARD EQUIPMENT: * Main line coalescent air filter * Manifold mounted air valves * Quick exhaust valve on blow line * Mold safety bottle jam protection * Screw safety timer * RPM indicator for screw speed * 16-station water manifold * Hopper magnet * Machine mounting pads * Fully guarded with electrical interlock for operator safety |
| OPTIONAL EQUIPMENT: * 1, 2, or 3 parison die heads * Bottom blow attachment * Parison programming * Ram-down or Pull-up top finish unit * Dual pressure blow * Special extruder feed screws for engineering resins * Automation for spin-trimming and handle de-flashing * Proportional valve hydraulics |
 |