Technical Papers Plastics
Polyvinylidene fluoride enables capacitors store and release large amounts of energy quickly

Polyvinylidene fluoride enables capacitors store and release large amounts of energy quickly

Means by which polyvinylidene fluoride (PVDF) enables capacitors to store and release large amounts of energy quickly has been discovered by researchers at North Carolina State University. ScienceDaily reports their findings could lead to much more powerful and efficient electric cars. Capacitors are like batteries in that they store and release energy. However, capacitors use separated electrical charges, rather than chemical reactions, to store energy. The charged particles enable energy to be stored and released very quickly. No batteries can power an electric vehicle that can accelerate from zero to 60 miles per hour at the same rate as a gasoline-powered sports car, because they release their energy too slowly. Capacitors, however, could be up to the job -- if they contained the right materials. NC State physicist Dr. Vivek Ranjan had previously found that capacitors which PVDF, in combination with another polymer called CTFE, were able to store up to seven times more energy than those currently in use. Ranjan, fellow NC State physicist Dr. Jerzy Bernholc and Dr. Marco Buongiorno-Nardelli from the University of North Texas, did computer simulations to see how the atomic structure within the polymer changed when an electric field was applied. Applying an electric field to the polymer causes atoms within it to polarize, which enables the capacitor to store and release energy quickly. They found that when an electrical field was applied to the PVDF mixture, the atoms performed a synchronized dance, flipping from a non-polar to a polar state simultaneously, and requiring a very small electrical charge to do so. Usually when materials change from a polar to non-polar state it is a chain reaction -- starting in one place and then moving outward. In terms of creating an efficient capacitor, this type of movement doesn't work well -- it requires a large amount of energy to get the atoms to switch phases, and you don't get out much more energy than you put into the system. In the case of the PVDF mixture, the atoms change their state all at once, which means that you get a large amount of energy out of the system at very little cost in terms of what you need to put into it.
Hopefully these findings will bring us even closer to developing capacitors that will give electric vehicles the same acceleration capabilities as gasoline engines.
  Back to Articles

Previous Article

Next Article

{{comment.Name}} made a post.




There are no comments to display. Be the first one to comment!


Name Required.


Email Id Required.

Email Id Not Valid.


Mobile Required.

Email ID and Mobile Number are kept private and will not be shown publicly.

Message Required.

Click to Change image  Refresh Captcha



Lohia tape stretching line

Lohia tape stretching line