Stretch moulded PET cups - an alternative to injection moulded and thermoformed products

Techno - commercial information on plastics Industry - News on Plastics Industry - Plastemart.com

Stretch moulded PET cups - an alternative to injection moulded and thermoformed productssss

PET cups have been produced either by thin wall injection moulding or thermoforming process so far. A new process has been developed by Frontier Japan that uses two stage rotary reheat stretch blow moulding to manufacture about 200-240 cups/minute using 12 cavities in the blow moulding stage.
The advantages of enhanced clarity and higher strength as well as barrier properties on account of orientation imparted by stretch blow moulding process can be observed in PET cups made by this new process.
Additionally scrap generation compared to thermoforming can be minimised. Frontier also claims to achieve about 64% orientation in the two stage process compared to about 50% achieved in a single stage stretch blow moulding process. This is mainly due to the fact that 3.2x orientation is achieved in two stage process compared to only about 2.2x in a single stage process.
The new process is already commercialized for chilled coffee. These cups are now likely to be used for fruit and milk based products. Frontier is now planning to develop this process for PP cups in sizes ranging from 100-600 ml. Further development for a multilayer cup based on PP or PET with a barrier layer of aromatic polyamide is also a distinct possibility.

Also Read
	Automotive	Automotive markets to provide growth stimulus to additive demand
	Will	Will new polystyrene grades with high impact and gloss penetrate the ABS market ?